Self-check

Office Wi-Fi troubleshooter.

Eight questions about how your office Wi-Fi is set up. Answer yes, no or not sure. Each no points to a likely cause of slow or dropping Wi-Fi.

The questions

Question 1 of 8

  1. An access point in each work area

    Is there a Wi-Fi access point in each area where people work?

    One router in the comms cupboard rarely reaches the far desks. Walls, lift cores and glass partitions all weaken the signal.

    Place access points from a floor plan or a walk through the site, so that every work area has one close by.

  2. Access points cabled to a switch

    Is every access point connected by a data cable, with no wireless extenders or repeaters?

    A repeater has to receive everything over the air and send it again, which slows down whatever sits behind it.

    Run a data cable to each access point. Where a cable can't be run, treat that wireless hop as the weak spot and keep as few devices behind it as possible.

  3. Channels and power set for the building

    Have the channels and power levels on your access points been set for your building?

    Left on defaults, nearby access points can end up on the same channel and talk over each other. Neighbouring offices add to it.

    Have someone look at how busy each channel is, then set the channel, width and power for each access point. Access points fixed to the same channel are one of the things our audits find.

  4. Roaming between access points

    Can you walk through the office on a video call without it dropping?

    A phone or laptop tends to hold on to the access point it first joined, even when a closer one is available.

    Roaming depends on where the access points sit and how their power is set. It is tuned, then tested by walking the floor on a call.

  5. Guests and devices on separate networks

    Is guest Wi-Fi separate from the network your computers and printers are on?

    Smart TVs, cameras and visitors' phones don't need to reach your files, and they compete for the same airtime.

    Give guests their own network that reaches the internet and nothing else, and put TVs, cameras and similar devices on one of their own as well.

  6. Equipment still supported

    Does your Wi-Fi equipment still get updates from its maker?

    Equipment that no longer gets updates keeps its known security flaws. ASD advises upgrading products that have reached end of support.

    Check each model against the maker's end-of-life list and plan to replace what is no longer supported.

    Source: ASD, End of support (opens in a new tab)

  7. Monitoring and alerts

    Does someone get an alert when an access point or the internet connection goes offline?

    If the first you hear of a fault is staff complaining, answer no.

    Have the network monitored so that a fault raises a ticket. On our managed networks every UniFi device and internet line is checked every 2 minutes, and a ticket opens when one has been down for 10.

  8. A backup internet connection

    Is there a second internet connection that takes over when the main one drops?

    Wi-Fi often gets the blame for an internet outage. To staff the two look the same.

    Add a second link or a 4G or 5G backup that takes over automatically. Our 4G/5G backup service is from $79 a month ex GST. See business internet.

Next step

Get a network quote.

Tell us about the site and what is going wrong. If you already have UniFi we can diagnose the problem or audit the setup, and audits are quoted per job. We reply within one business hour. Or call 02 9188 8000.

Fields marked asterisk are required

Behind the questions

How to read the result.

What the questions cover, what they can't see and what happens if the network needs replacing.

What the questions cover

When Wi-Fi keeps dropping, common causes are access points on overlapping channels, a faulty or slow cable run and firmware bugs. The questions cover the causes you can answer from your desk: where the access points are, how they connect and how they are set.

What a quiz can't see

A quiz can't measure interference, test a cable or read a device's logs. For that, someone has to look at the network. If you already have UniFi, we can diagnose the problem from the console or carry out a full audit, which is quoted per job.

If it needs replacing

For a new network we work from your floor plans to place the access points and switches, supply the hardware and set it up. Our managed network plan is from $500 a month ex GST with CyberSecure included. We help maintain over 400 UniFi networks across Australia.

FAQ

Common questions.

Why does our office Wi-Fi keep dropping out?
Common causes are access points on overlapping channels, a faulty or slow cable run, and firmware bugs. Too few access points for the space and wireless repeaters are setup causes that the eight questions also cover.
Do we need UniFi for you to help?
UniFi is what we install most often. We also design and support Cisco Meraki networks where a client already has them or prefers them. If you have something else, we can quote a new network.
What does a UniFi audit include?
Three sources of evidence and a written report. We read every setting in the UniFi console, scan and measure the network on site, and check firmware, published vulnerabilities and out-of-support hardware against Ubiquiti's own pages. Every finding is rated critical, high or medium, and nothing is changed during the audit. Audits are quoted per job.
How much does a managed UniFi network cost?
Our managed network plan starts at $500 a month ex GST. It includes remote monitoring every 2 minutes from the AyeTech Hub, Ubiquiti's CyberSecure subscription, security patches, investigation of serious alerts, remote fixes in business hours and small changes on request. New equipment, on-site visits and internet charges are separate.
Do you see my answers?
Only if you send the enquiry form. The result is worked out in your browser. If you send the form after answering, your answers are included so the engineer knows where to start, and the form shows you what will be sent. We count how many people start and finish the troubleshooter, and we don't record the answers.

Want the network itself looked at?

Answers only go so far. We can read the console and measure the site, then tell you what we found and what it would take to fix.

Related: UniFi networks, what a UniFi audit covers, business internet and more self-checks.

Call Get a network quote